Endress+Hauser Proline Promass 80 - Performing a zero point adjustment

Device Functions Proline Promass 80 14 Group PROCESS PARAMETER
Endress+Hauser 53
PRESSURE
! Note!
This function is not available unless FIX was selected in the PRESSURE MODE function.
Use this function to enter the value for the process pressure which should be used during
pressure correction.
User input:
7-digit floating-point number
Factory setting:
0 bar g
! Note!
The appropriate unit is taken from the function group SYSTEM UNITS (see Page 8).
Function description PROCESS PARAMETER