Endress+Hauser Proline Promass F 100 - Performing a Totalizer Reset

Proline Promass F 100 Modbus RS485 Operation
73
Navigation
"Diagnostics" menu → Measured values → Totalizer
‣
Totalizer
Totalizer value 1 to n
→  73
Totalizer overflow 1 to n
→  73
Parameter overview with brief description
Parameter Prerequisite Description User interface
Totalizer value One of the following options is selected
in the Assign process variable
parameter (→  66)Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
Displays the current totalizer counter
value.
Signed floating-point
number
Totalizer overflow One of the following options is selected
in the Assign process variable
parameter (→  66)Totalizer 1 to n
submenu:
• Volume flow
• Mass flow
• Corrected volume flow
• Target mass flow
*
• Carrier mass flow
*
Displays the current totalizer overflow. Integer with sign
* Visibility depends on order options or device settings
11.4 Adapting the measuring device to the process
conditions
The following are available for this purpose:
• Basic settings using theSetup menu (→  52)
• Advanced settings using theAdvanced setup submenu (→  62)
11.5 Performing a totalizer reset
The totalizers are reset in the Operation submenu:
• Control Totalizer
• Reset all totalizers