Endress+Hauser Proline t-mass 65F - Page 30

11 Group PULSE/FREQUENCY OUTPUT Device Functions Proline t-mass 65
30 Endress+Hauser
OUTPUT SIGNAL For selecting the output configuration of the FREQUENCY output.
! Note!
Function is not available unless the FREQUENCY setting was selected in the OPERA-
TION MODE function.
Options:
0 = PASSIVE - POSITIVE
1 = PASSIVE - NEGATIVE
2 = ACTIVE - POSITIVE
3 = ACTIVE - NEGATIVE
Factory setting:
PASSIVE - POSITIVE
! Note!
Options ACTIVE - POSITIVE and ACTIVE - NEGATIVE are only available if flexible I/O
boards are fitted (see Technical Information in the Operating Instructions)
Explanation
• PASSIVE = power is supplied to the frequency output by means of an external power
supply.
• ACTIVE = power is supplied to the frequency output by means of the device-internal
power supply.
Configuring the output signal level (POSITIVE or NEGATIVE) determines the quiescent
behaviour (at zero flow or minimum temperature) of the frequency output.
The internal transistor is activated as follows:
• If POSITIVE is selected, the internal transistor is activated with a positive signal level.
• If NEGATIVE is selected, the internal transistor is activated with a negative signal
level (0 V).
! Note!
With the passive output configuration, the output signal levels of the frequency output
depend on the external circuit (see examples).
Example for passive output circuit (PASSIVE)
If PASSIVE is selected, the frequency output is configured as an open collector.
A0001225
m = Open collector
n = External power supply
! Note!
For continuous currents up to 25 mA (I
max
= 250 mA / 20 ms).
Example for output configuration PASSIVE-POSITIVE:
Output configuration with an external pull-up resistance. In the quiescent state (at zero
flow or minimum temperature), the output signal level at the terminals is 0 V.
A0004687
m = Open collector
n = Pull-up resistance
o = Transistor activation in POSITIVE quiescent state (at zero flow or minimum tem-
perature)
p = Output signal level in quiescent state (at zero flow or minimum temperature)
Function description PULSE/FREQUENCY OUTPUT
1
5
8 3
7
+
-
=
U =30VDC
max
m
n
U =30VDC
max
+
U (V)
t
U (V)
t
o
p
m
n