17 Group GAS MIXTURE Device Functions Proline t-mass 65
62 Endress+Hauser
GAS TYPE 8 View Gas Type 8.
! Note!
This function is not available if NUMBER OF GAS COMPONENTS selection is <8
Display:
Gas list the same as GAS TYPE 1
Factory setting:
NOT DEFINED
% FRACTION 8 View % Fraction 8.
! Note!
This function is not available if NUMBER OF GAS COMPONENTS selection is <8
Display:
000.00 % to 100.00 %
Factory setting:
000.00 %
CHECK VALUES This function checks the entered gas mixture values.
! Note!
This function is only available if the gas mixture fractions do not = 100%.
Display:
MIXTURE NOT 100%
SAVE CHANGES Use this function to control editing of the gas mixture table.
! Note!
This function is not available if error MIXTURE NOT 100% is displayed in CHECK VAL-
UES.
User interface:
CANCEL
YES
DISCARD
! Note!
• If CANCEL selected; entered parameters are saved in memory but are not used for
flow calculations.
• If YES selected; entered parameters are saved in memory and are used for flow calcula-
tions.
• If DISCARD selected; entered parameters are discarded, the previous parameters
remain valid and are used for flow calculations.
Caution!
The settings are not saved if the power supply fails during entry of the gas mixture.
Function description GAS MIXTURE
To Next Page
Loading...
