Endress+Hauser RIA14 - 4.3 Post-installation check; 5 Electrical connection; 5.1 Connection requirements

Electrical connection RIA14
10 Endress+Hauser
1
2
3
1.
2.
3.
A0011258
 3 Pipe mounting of the device with mounting bracket
1 Mounting plate
2 Mounting bracket
3 2 M6 nuts
1. Applies to pipes with a diameter of 38 to 56 mm (1.5 to 2.2 in).
Attach the mounting bracket to the pipe.
2. Push the mounting plate onto the mounting bracket.
3. Fit the device on the mounting bracket with the two nuts (M6) supplied. The
mounting plate is not necessary for pipes with a diameter of
56 to 84 mm (2.2 to 3.3 in).
4.3 Post-installation check
Perform the following checks after mounting the device:
Device condition and specifications Notes
Is the measuring device damaged? Visual inspection
Is the seal undamaged? Visual inspection
Is the device fixed securely to the wall or mounting plate? -
Is the housing cover firmly mounted? -
Does the device match the measuring point specifications (ambient temperature,
measuring range etc.)?
See "Technical data" section
5 Electrical connection
5.1 Connection requirements
For information on the connection data, see the "Technical data" section.
NOTICE
Destruction or malfunction of parts of the electronics
‣
ESD - Electrostatic discharge. Protect the terminals from electrostatic discharge.
L
CAUTION
Destruction of parts of the electronics
‣
Switch off the power supply before installing and connecting the device.