Endress+Hauser RIA14 - 2 Basic safety instructions; 2.1 Requirements for the personnel; 2.2 Intended use; 2.3 Workplace safety

RIA14 Basic safety instructions
Endress+Hauser 5
Document type Purpose and content of the document
Safety Instructions (XA) Depending on the approval, safety instructions for electrical equipment in
hazardous areas are also supplied with the device. The Safety Instructions
are an integral part of the Operating Instructions.

Information on the Safety Instructions (XA) relevant to the device is
provided on the nameplate.
Supplementary device-dependent
documentation (SD/FY)
Always comply strictly with the instructions in the relevant
supplementary documentation. The supplementary documentation is an
integral part of the device documentation.
2 Basic safety instructions
2.1 Requirements for the personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill
the following requirements:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Are authorized by the plant owner/operator.
‣
Are familiar with federal/national regulations.
‣
Before starting work, read and understand the instructions in the manual and
supplementary documentation as well as the certificates (depending on the
application).
‣
Follow instructions and comply with basic conditions.
The operating personnel must fulfill the following requirements:
‣
Are instructed and authorized according to the requirements of the task by the facility's
owner-operator.
‣
Follow the instructions in this manual.
2.2 Intended use
• The device is a configurable field indicator with one sensor input.
• It is designed for mounting in the field.
• The manufacturer accepts no liability for damages resulting from improper or non-
intended use.
• Safe operation is only guaranteed if the Operating Instructions are observed.
• Only operate the device in the permitted temperature range.
2.3 Workplace safety
When working on and with the device:
‣
Wear the required personal protective equipment as per national regulations.
2.4 Operational safety
Damage to the device!
‣
Operate the device in proper technical condition and fail-safe condition only.
‣
The operator is responsible for the interference-free operation of the device.