Endress+Hauser RIA14 - 4.2.1 Turning the display; 4.2.2 Direct wall mounting; 4.2.3 Pipe mounting

RIA14 Mounting
Endress+Hauser 9
The backlit display can be mounted in four different positions →  8.
It is essential that you clean and lubricate the thread prior to mounting.
4.2.1 Turning the display
Pos. 1
2
3
1
4
1.
2.
90°
90°
90°
Pos. 2 Pos. 3 Pos. 4
3.
A0023724
 2 Field indicator, 4 display positions, can be fitted in 90° steps
The display can be turned in 90° steps.
1. Remove the cover clamp (1) and the housing cover (2).
2. Remove the display (3) from the electronics unit (4).
3. Turn the display to the desired position and then attach it to the electronics unit.
4. Clean the thread in the housing cover and housing base and lubricate if necessary.
(Recommended lubricant: Klüber Syntheso Glep 1)
5. Screw the housing cover (2) and O-ring together and fit the cover clamp (1) back on.
4.2.2 Direct wall mounting
Procedure for direct wall mounting of the device:
1. Drill 2 holes (see dimensions, →  1,  8)
2. Attach the device to the wall with 2 screws ⌀5 mm (0.2 in).
4.2.3 Pipe mounting
The mounting bracket is suitable for pipes with a diameter of 38 to 84 mm (1.5 to 3.3 in).