Enterasys SecureStack A2 A2H124-24P - Management and Connectivity

Management
1-6 Introduction
Management
Managementofthemodulecanbeeitherin‐bandorout‐of‐band.In‐bandremote
managementispossibleusingTelnet,Enterasys Networks’NetSight
®
management
application,ortheWebViewapplication.Out‐of‐bandmanagementisprovidedthrough
theDB9ConsoleportconnectoronthefrontpanelusingaVT100terminaloraVT100
terminalemulator.
Switch Configuration Using WebView
Enterasys Networks’HTTP‐basedWebmanagementapplication(WebView)isan
intuitivewebtoolforsimplemanagementtasks.
Switch Configuration Using CLI Commands
TheCLIcommandsenableyoutoperformmorecompleteSecureStackA2configuration
managementtasks.
ForCLIcommandsetinformationandhowtoconfigurethemodule,refertothe
SecureStackA2ConfigurationGuide.
Standards Compatibility
The100BASE‐Tports arecompliantwiththef o llowingstandardsandoperations:
• IEEE802.3
• IEEE802.3u
• IEEE802.3ab(StackPorts)
• IEEE802.3ad
• IEEE802.3af
•Full‐Duplexoperation
Inadditiontotheabovestandards,theSFPportsarecompliantwiththefollowing
standardsandoperations:
• IEEE802.3z
• IEEE802.3xFlowControlsupportforFull‐Duplexmode
•Auto‐negotiationforFull
‐Duplexcontroloperations