6.1 Connecting Ethernet and power cables 32
6.2 Connecting the optional USB keyboard 33
6.2.1 Configuring an nShield Connect for your keyboard type 33
6.3 Checking the installation 33
7 Front panel controls 34
8 Top-level menu 35
8.1 System 36
8.2 HSM 38
8.3 Security World mgmt 38
9 Basic nShield Connect, RFS and client configuration 40
9.1 About nShield Connect and client configuration 40
9.1.1 Remote file system (RFS) 40
9.1.2 nShield Connect configuration 41
9.1.3 Client configuration 41
9.2 Basic nShield Connect and RFS configuration 41
9.2.1 Configuring the Ethernet interfaces - IPv4 and IPv6 41
9.2.1.1 IPv4 and IPv6 42
9.2.1.1.1 IPv6 Addresses 42
9.2.1.1.2 IPv6 Address notation 42
9.2.1.1.3 IPv6 Compliance 43
9.2.1.1.4 Acceptable IPv6 Address by Use Case 43
9.2.1.2 Stateless Address Auto Configuration (IPv6 only) 45
9.2.2 Configure Ethernet Interface #1 46
9.2.2.1 Enable/disable IPv4 46
9.2.2.2 Set up IPv4 static address 46
9.2.2.3 Enable/disable IPv6 47
9.2.2.4 Set up IPv6 static address 47
9.2.2.5 Set the link speed for Interface #1 48
9.2.3 Configure Ethernet Interface #2 48
9.2.4 Default gateway 49
nShield® Connect - Installation Guide
Page 5
To Next Page
Loading...