Entrust nShield Connect v12.50.4 - Page 5

9.2.4.1 Set default gateway for IPv4 49
9.2.4.2 Set default gateway for IPv6 49
9.2.5 Set up Routing 50
9.2.5.1 Set up routing for IPv4 50
9.2.5.2 Set up routing for IPv6 51
9.2.6 Edit route entry 52
9.2.6.1 Edit IPv4 route entry 52
9.2.6.2 Edit IPv6 route entry 52
9.2.7 Remove route entry 54
9.2.8 Enable IPv6 SLAAC 54
9.2.9 Configuring the Remote File System (RFS) 54
9.2.9.1 Systems configured for Remote Administration 56
9.3 Basic configuration of the client to use the nShield Connect 56
9.3.1 Client configuration utilities 56
9.3.1.1 nethsmenroll 56
9.3.1.2 config-serverstartup 57
9.3.2 Configuring a client to communicate through an nToken 58
9.3.3 Enrolling the client from the command line 58
9.3.4 Configure the TCP sockets on the client for Java applications (for example, KeySafe) 59
9.4 Basic configuration of an nShield Connect to use a client 59
9.5 Restarting the hardserver 61
9.6 Checking the installation 62
9.7 Using a Security World 62
10 Troubleshooting 63
10.1 Checking operational status 63
10.1.1 Enquiry utility 63
10.1.2 Status LED 64
10.1.3 Audible warning 65
10.1.4 Orange warning LED 65
10.1.5 Checking the physical security of the module 65
Page 6
nShield® Connect - Installation Guide