Section 1: Safety
4
The operator of the Epilog Model 10000 should observe the following general
precautions:
DO NOT disassemble the machine or remove any of its protective covers
while the unit is plugged in.
DO NOT attempt to defeat the door interlocks.
DO NOT view directly into the beam of the Laser Diode Pointer (Red Dot
Pointer).
DO NOT operate the Laser Diode Pointer (Red Dot Pointer) without the
machine’s focus lens in place.
Caution – Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous laser radiation exposure.
* * *
The standard reference for laser safety is the American Standard for the Safe Use
of Lasers, Z136.1-2000, developed by the American National Standards Institute
(ANSI). This reference is the basis for many of the federal regulations for laser
and laser system manufacturers, and for the Occupational Safety and Health
Administration (OSHA) laser safety guidelines. It contains detailed information
concerning proper installation and use of laser systems.
While the ANSI standard itself does not have the force of law, its
recommendations, including warning signage, training, and the designation of a
laser safety officer, may be compulsory under local workplace regulations when
operating laser systems above Class I. It is the operator’s responsibility to ensure
that the installation and operation of the Epilog Model 10000 Laser System is
performed in accordance with all applicable laws.
Copies of ANSI Standard Z136.1-2000 are available from Epilog Corporation or
from:
Laser Institute of America
12424 Research Parkway, Suite 125
Orlando, FL 32826
(407) 380-1553
To Next Page
Loading...
Need help?
General