Section 16: Specifications
214
Summary
Computer Recommendations:
Windows 2000, XP or 32 bit Vista
2 GB RAM Minimum
CD-ROM or DVD
2.0 GHz or faster Processor
10/100 Network Interface Card
80 GB Hard Drive - (Minimum)
CorelDraw or other Windows based software
About The Laser
Your Epilog CO2 laser system uses the latest in laser technology to provide a
powerful tool that is simple and safe to setup and operate. The Epilog laser can mark,
engrave, and cut a variety of materials.
The CO2 laser beam itself is invisible. The beam is about half the diameter of a #2
pencil. Unfocused, it will just make an ugly burn, leaving lots of charred material
behind. The focus lens gives the beam an hourglass shape. At the center point the
energy density is concentrated, allowing the very precise and clean material removal
that is characteristic of laser engraving. The center of the hourglass is the “focal
point”.
The laser beam path is completely enclosed within the cabinet. Please do not
disassemble or modify any of the covers or windows on the machine. If at any time
you notice that the laser operates with a door or window open, please contact Epilog
technical support immediately.
To Next Page
Loading...
Need help?
General