156
Section 10: Engraving
Machine Cleaning
In This Section
Cleaning Important!
Laser Tube
Cleaning - Important!
Fire Warning!
Through normal use your laser system can collect debris and soot that are potentially
flammable. Keeping you laser system clean and the area around it clean are
important parts of laser maintenance. Some materials are extremely flammable and
can easily ignite and burst into open flame setting the machine afire. This open flame
is very dangerous and has the potential to destroy not only the machine, but the
building in which it is housed.
Please read the following warnings and recommendations and follow them closely at
all times!
NEVER let the laser system operate if it will be unattended.
KEEP the area around the machine clean and free of clutter, combustible
materials, explosives, or volatile solvents such as acetone, alcohol, or
gasoline.
ALWAYS keep a properly maintained and inspected fire extinguisher on hand.
Epilog recommends a Halotron fire extinguisher or a multi-purpose dry
chemical fire extinguisher. The Halotron extinguishers are more expensive
than a dry chemical, but offer certain advantages should you ever need to use
an extinguisher. The Halotron extinguisher discharges a clean, easily
removable substance that is not harmful to the mechanics or wiring of the
laser system. The dry chemical extinguisher discharges a sticky, corrosive
powder that is very difficult to clean up.
ALWAYS use the Air Curtain when vector cutting.
To Next Page
Loading...
Need help?
General