Epilog Laser Zing 10000 - Page 202

Section 13: Material Engraving Techniques
188
INCORRECT SETUP USING A FENCE IN COMBINED MODE
CORRECT SETUP WHEN USING PAGE SIZE IN COMBINED MODE
Once you have successfully set up your stamp artwork, you are ready to print your
design. In the Dashboard go to the Advanced tab:
Incorrect Example # 1 –
The stamp is missing a
fence.
Incorrect Example # 2 –
This setup contains
multiple fences.
If you are using
the page size
method, simply
nest your stamps
so you are most
efficient with
your engraving.
Any line of .001
inch (.025 mm)
will be vector
cut.