Appendix C Additional Dashboard Instructions
250
Select Create a new
port:
In the drop down
menu, select
Standard TCP/IP
Port.
Click Next> to
continue
For Device Type:
select TCP/IP
Device,
Type in 192.168.3.4
for the Hostname or
IP a
ddress.
Click Next to
continue.
Enter the same IP address that you set in the laser using the EXT keyboard (Step 1
in this procedure). It is important that the IP address you use is the same in both
places. The format of the numbers looks a little different. In the control panel of
the laser the IP address will look like this: 192.168.003.004. When you enter the
IP address in this window, you do not need the zeros, and the address will look
like this: 192.168.3.4
To Next Page
Loading...