Section 6: Quick Start and Easy Setup
44
www.epiloglaser.com
Speed
STOP RESETGO
Pointer X/Y Off
Config
Data
Power Focus Job
0
12
3
6
7
3
4
5
89
Job:1.Sample.cdr
12. The job you sent over most recently is shown in the LCD display.
13. To run that job, just press the GO button on the keyboard.
14. To run a previous job, press the JOB button on the keypad and then scroll
through the sent jobs by pressing the UP Arrow key or the Down Arrow
Key. The corresponding job names will be displayed in the LCD Display
Panel. If more than one job of the same name is sent over, it is numbered
after the word Job.
15. Press GO when the job to be run is displayed in the LCD Display Panel.
The job will now start.
To Next Page
Loading...
Need help?
General