Section 7: Using the Epilog Dashboard
60
Example: The rectangle below has a line weight of 0.003 inch. It will not raster
engrave at any resolution (see following chart). If you send just this box to the
laser in Raster mode and try to run the job, the laser will beep once and be
finished because the line is too small to be recognized as an engraving line.
Resolution
100 200 250 400 500 1000
.001
No No No No No No
.002
No No No No No No
.003
No No No No No No
.004
No No No No No
Yes
.005
No No No
Yes
No
Yes
.006
No No No
Yes Yes Yes
Line Weight (inches)
.007
No No No
Yes Yes Yes
.008
No No
Yes Yes Yes Yes
Line weight = 0.003 inch.
Engraving Line Weights
Line weights that will engrave at different resolutions (DPI) when in Raster
or Combined mode.
To Next Page
Loading...