ePropulsion eLite User Manual

24
4.2 Motor Installation
Ensure that the clamp bracket is securely installed, as a loose clamp bracket may cause
the outboard motor to fall into the water or get damaged. Check the clamp handles before
each use, as they may loosen due to mechanical vibrations.
If the quick-release mount is stuck, please rinse it clean before installing the motor.
It is recommended to use a rope or chain through the lanyard hole to connect the
outboard motor and the boat, to prevent the motor from falling off the bracket, which may
result in loss or submersion.
Figure 4.3
Step 1: Pull out or rotate the tiller adjustment toggle to unfold the tiller (see section 2.1).
Figure 4.4
Lanyard Hole
1 2 3
4
A
B
3 2 1
B
A
C
D
C
g
单位:mm
Guangdong ePropulsion Technology Limited
广东逸动科技有限公司
4
版本 变更记录 ECN编号 设计 变更日期
A
1 2 3
4
A
B
3 2 1
B
A
C
D
C
g
单位:mm
Guangdong ePropulsion Technology Limited
广东逸动科技有限公司
4

ePropulsion eLite Specifications

General

Brand	ePropulsion
Model	eLite
Category	Outboard Motor
Language	English