27
5 Operation
5.1 Checklist before start
1. Ensure the battery has sufficient charge. Press the power button once to display the
remaining battery level on the display.
2. Ensure that the clamp bracket is securely fastened to the transom in the correct position.
3. Ensure the propeller is correctly installed on the outboard motor.
4. Ensure the throttle is in neutral position.
5. Ensure the throttle can move smoothly.
5.2 Starting
The ePropulsion eLite electric outboard motor has two working modes: Standard mode and
Sport mode.
Standard mode: The maximum output power of the outboard motor is 500W.
Sport mode: The maximum output power of the outboard motor is 750W.
In the event of serious fault, the motor will immediately stop working and display the
corresponding error code on the screen. For less serious faults it will enter a reduced power
mode. Please refer to Section 6.5 for details.
5.2.1 Standard Mode
The ePropulsion eLite electric outboard motor starts in Standard mode, with a maximum
output power of 500W. The maximum output power will reduce as the battery level falls or if the
temperature rises above normal limits. For details, please refer to Section 6.4.
The steps to start the outboard motor are as follows:
Step 1: Attach the kill switch wristband to your wrist or life jacket.
Figure 5.1
To Next Page
Loading...
