Chapter 3 Removal and Replacement Procedures Revision B
Epson AcuLaser C2900N 3 - 58 Confidential
7) Fit the ROLL ASSY FEED to the SHAFT
ASSY FEED with the groove of the ROLL
ASSY FEED facing upward, rotate the
ROLL ASSY FEED 180 degrees so that
the pin on the SHAFT ASSY FEED is
aligned with the groove on the ROLL
ASSY FEED.
8) Open the COVER ASSY FRONT MG.
9) Move the ROLL ASSY FEED to the right
side, put the groove of the ROLL ASSY
FEED on the pin of the SHAFT ASSY
FEED.
To Next Page
Loading...
