Epson AcuLaser C2900N - Executing Parameter (Printing the Parameter List)

2 - 47
Chapter 2 Operation of Diagnostic
Epson AcuLaser C2900N
Revision B
Confidential
4.6.3 Executing Parameter (Printing the parameter list)
1) Turn off the power.
2) Turn on the power while holding down "S" and "T" keys.
3) Release the fingers from these keys when the "CE Mode" and "Password" is displayed.
4) Press "T" key twice and press "OK" key.
5) The "CE Mode" and "ESS Diag" are displayed. (Entered the Diag. mode.)
6) Press "T" to select "Parameter", and then press "OK" key.
7) Press "T" key to select the "Print", and then press "OK" key.
The parameter list is printed.
To exit the test or to returning to one step higher menu, press "STOP" key.