Epson AcuLaser C2900N - Image Quality FIP

1 - 134
Chapter 1 Troubleshooting
Epson AcuLaser C2900N
Revision B
Confidential
4.3 Image Quality FIP
FIP-1.P1 The output is too light
ESS and possible causative parts
- TRANSFER ASSY (PL6.1.7)
- DRUM CARTRIDGE (PL4.1.21)
- DISPENSER ASSY (PL5.1.1)
- ROS ASSY (PL4.1.1)
- PWBA HVPS (PL4.1.19)
Before commencing troubleshooting, check the paper transfer path. Make sure there is no foreign
materials on the transfer path, such as staples, paper clips, scraps of paper and so on.
Step Check
Remedy
Yes No
1
Checking the printing.
Checked by [Test Print] - [Gradation] in diagnosis.
Is the image printed correctly?
Printing data is
incorrect, then
check the printing
data which the
problem
generated.
Go to step 2.
2
Changing the printer driver setting.
1.Reset Image Settings (Brightness/Contrast) to defaults.
- Click [Restore Defaults] in [Image Settings] on the
[Graphics] tab.
2.Disable Toner Saving Mode.
- Deselect the [Toner Saving Mode] check box on the
[Advanced] tab.
Is the image printed correctly?
End of work. Go to step 3.
3
Checking the paper.
Is the installed paper with a new and dry one? or does the
paper satisfy the specification?
Go to step 4.
Replace the paper
with a new and dry
one. or Change
the paper to the
one that satisfies
the specification.
Mnt01100KA
Mnt01101KA
Faint