Chapter 3 Removal and Replacement Procedures Revision B
Epson AcuLaser C2900N 3 - 207 Confidential
RRP8.7 SENSOR HUM (PL8.2.7)
[Removal]
1) Remove the CASSETTE ASSY 250. (RRP2.1)
2) Open the COVER ASSY FRONT MG (PL1.2.1).
Note: Cover the drum of the DRUM CARTRIDGE to avoid exposure to light.
3) Remove the DRUM CARTRIDGE. (RRP4.6)
Note: The FUSING part is very hot. Take added care not to get burned when performing the
service operation.
4) Remove the FUSER UNIT. (RRP6.1)
5) Remove the COVER ASSY TOP. (RRP1.1)
6) Remove the COVER SIDE L. (RRP1.7)
7) Remove the one screw (silver, tap,
8mm) that fixes the SENSOR HUM
(PL8.2.7) to the printer, remove the
SENSOR HUM.
8) Disengage the connector (P/J201) of
the SENSOR HUM.
To Next Page
Loading...
