Sub-menu Function
Reset
You can reset all adjustment values on the Signal menu to their
default settings, except for Input Signal.
See the following to return all menu items to their default
settings.
s "Reset Menu" p.115
Settings Menu
Sub-menu Function
Keystone
You can correct keystone distortion.
• When H/V-Keystone is selected:
Adjust V-Keystone and H-Keystone to correct horizontal
and vertical keystone distortion.
• When Quick Corner is selected:
Select and correct the four corners of the projected image.
s "Quick Corner" p.46
Zoom
Adjusts the projected image size.
Sub-menu Function
Image Shift
Starts Image Shift.
s "Adjusting the Position of the Image (Image Shift)" p.48
Control Panel
Lock
You can use this to restrict operation of the projector's control
panel.
s "Restricting Operation (Control Panel Lock)" p.82
Pointer Shape
You can select the shape of the pointer.
Pointer 1:
Pointer 2:
Pointer 3:
s "Pointer Function (Pointer)" p.68
Power Consump‐
tion
You can set the lamp brightness to one of two settings.
Select ECO if the images being projected are too bright, such as
when projecting images in a dark room or onto a small screen.
When ECO is selected, the amount of electricity consumed and
the lamp's operating life are changed as follows, and fan rotation
noise during projection is reduced.
Electrical consumption: Approx. 35% decrease, lamp life:
Approx. 1.3 times longer
Volume
You can adjust the volume. Setting values are saved for each
source.
Mic Input Level
Adjust this if the microphone input level is low and the
microphone audio output from the projector's speaker is difficult
to hear, or if the input level is too high, resulting in a crackling
sound in the audio from the microphone. When Mic Input Level
is turned down to 0, no microphone audio is output from the
speaker.
When the microphone input level is raised, the audio from the
connected device becomes quieter. When the microphone input
level is lowered, the audio from the connected device becomes
louder.
List of Functions
101
To Next Page
Loading...
Need help?
General
