Others menu
Sub-menu Function
SNMP
Set to On to monitor the projector using SNMP.
To monitor the projector, you need to install the SNMP manager
program on your computer. SNMP should be managed by a
network administrator.
The default value is Off.
Trap IP Address
1/Trap IP Ad‐
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination. You can enter a number from 0 to 255 in
each field of the address. However, the following IP addresses
cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x
is a number from 0 to 255)
Priority Gateway
You can set the priority gateway to a Wired LAN or Wireless
LAN.
AMX Device Dis‐
covery
When the projector is connected to a network, set this to On to
allow the projector to be detected by
AMX Device Discovery
g
.
Set this to Off if you are not connected to an environment
controlled with a controller from AMX or AMX Device
Discovery.
Sub-menu Function
Crestron Room‐
View
Set this to On only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to Off.
s "About Crestron RoomView
®
" p.90
When this is set to On, the following functions are not available.
• Web control
• Message Broadcasting (EasyMP Monitor Plug-in)
Bonjour
Set this to On when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
http://www.apple.com/
List of Functions
113
To Next Page
Loading...
Need help?
General
