C
Temp indicator Indicates the internal temperature status.
See the following table for the status of indicators and how to resolve the problems.
If all indicators are off, check that the power cord is connected correctly and that the power is being supplied normally.
Sometimes, when the power cord is unplugged, the [
t] indicator remains lit for a short period, but this is not an error.
: Lit : Flashing : Off : Varies according to the projector status
Status Cause Remedy or Status
Internal Error Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s Epson Projector Contact List
Fan Error
Sensor Error
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s Epson Projector Contact List
High Temp Error
(overheating)
The lamp turns off automatically and projection stops. Wait for approximately five minutes. After approximately five minutes the projector
switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are not blocked, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.138, "Replacing the Air Filter" p.142
If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.103
Lamp Error
Lamp Failure
Check the following two points.
• Take out the lamp and check whether it is cracked.
s "Replacing the Lamp" p.139
• Clean the air filter.
s "Cleaning the Air Filter" p.138
Problem Solving
119
To Next Page
Loading...
Need help?
General
