Caution
Wait until the Lamp has cooled down sufficiently before removing the Lamp
cover. If the lamp is still hot, burns or other injuries may result. It takes about
one hour after the power has been turned off for the Lamp to be cool enough.
Procedure
A
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cable.
B
Wait until the Lamp has cooled down, then remove the Lamp
cover.
Loosen the Lamp cover fixing screw with the screwdriver supplied
with the new lamp unit or a + head screwdriver. Then slide the Lamp
cover straight forward and lift it to remove.
C
Loosen the two Lamp fixing screws.
D
Take out the old Lamp by pulling the handle.
If the lamp is cracked, replace it with a new lamp, or contact your
local dealer for further advice.
s Epson Projector Contact List
Replacing Consumables
97
To Next Page
Loading...
Need help?
General
