c
Select On, and then press the [Enter] button.
Press the [Esc] button to return to the screen in step 2.
d
Set the password.
(1) Select Password, and then press the [Enter] button.
(2) When the message "Change the password?" is displayed, select Yes and
then press the [Enter] button. The default password is set to "0000".
Change this to your own desired Password. If you select No, the screen
displayed in step 2 is displayed again.
(3) While holding down the [Num] button, enter a four digit number using
the numeric buttons. The number entered is displayed as "* * * *". When
you enter the fourth digit, the confirmation screen is displayed.
Remote control
(4) Re-enter the password.
The message "Password accepted." is displayed.
If you enter the password incorrectly, a message is displayed prompting
you to re-enter the password.
Entering the Password
When the password entry screen is displayed, enter the password using the
remote control.
While holding down the [Num] button, enter the Password by pressing the
numeric buttons.
When you enter the correct password, Password Protect is temporarily
released.
Restricting Operation
The following three kinds of operation restriction functions are available
with the projector.
• Control Panel Lock
This is useful at events or shows when you want to deactivate all buttons
during projection or at schools when you want to limit button operation.
• Lens Operation Lock
This function deactivates all buttons on the remote control related to the
lens operation to prevent improper lens adjustment after it is properly
adjusted.
• Remote control button lock
This function deactivates buttons except for main buttons needed for
basic remote control operation, to prevent mistakes in operations.
Security Functions
45
To Next Page
Loading...
Need help?
General
