When Network Protection is set to On in Password Protection, a message
is displayed and the network settings cannot be changed. Set Network
Protection to Off and then configure the network.
Checking Network Settings
You can use one of the following methods to check the network setting
information.
• Checking from the Configuration menu.
Press the [Menu] button, and then select Net. Info - Wireless LAN or
Net. Info - Wired LAN from the Network menu to display the current
network settings.
• Checking from the LAN Standby screen.
Press the [LAN] button on the remote control to display the following
information.
Projector Name, SSID, IP Address, Keyword
Wireless LAN
Preparing the Projector
• To connect the projector to a computer using wireless LAN, you need
to install the optional wireless LAN unit on the projector.
• Perform network settings so that the computer can use wireless LAN.
For more details, see the user's guide supplied with the computer.
Ad hoc connection settings (Quick)
When using the "EasyMP Network Projection" software supplied, this setup
method creates a direct wireless connection (ad hoc connection) between
the computer and the projector.
a
Display the Network Configuration screen on the projector.
Press the [Menu] button > Network > Network Configuration
b
Select the Wireless LAN menu.
The following screen is displayed.
c
Set Wireless LAN Power to On.
d
Set Connection Mode to Quick.
e
Set other items as necessary.
Submenu Function
Wireless LAN system Sets the wireless LAN system. Normally this should be
set to 802.11b/g/n.
SSID Auto Setting When you set this to On, you can search for the
projector more quickly from among multiple
projectors. SSID is set automatically. When
connecting to multiple projectors from 1 computer,
set this to Off, and set the same SSID in all the
projectors that will connect.
Network Setup
48
To Next Page
Loading...
Need help?
General
