Submenu Function
SMTP Server
You can input the IP address for the SMTP server for the
projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Port Number
You can input the port number for the SMTP server. The default
value is 25. You can input numbers between 1 to 65535.
Email Address 1/
Email Address 2/
Email Address 3
You can input the email address of the destination to send the
notification email to. You can register up to three destinations.
You can enter up to 64 single-byte alphanumeric characters for
the email addresses. ( " ( ) , ; < > [ ¥ ] cannot be used.)
You can enter up to 32 characters on the Configuration menu.
When entering more than 32 characters, use your Web browser
to enter the text.
The address for destination 1 is the mail notification sender's
address.
Setting a Notifi‐
cation Event
You can select the problems or warnings to be notified about by
email. When the selected problem or warning occurs in the
projector, an email is sent to the specified Email Address
notifying that a problem or warning has occurred. You can select
multiple items from the displayed items.
Manage Certificates menu
Submenu Function
Client Certificate
Displays the Issued to, Issued by, and Validity period
information set in the stored client certificate. It is blank if the
certificate is not set. You need to set Client Certificate when
WPA/WPA2-EAP is selected in Security, and PEAP-TLS or
EAP-TLS are selected in EAP Method.
Select Clear to delete the stored certificate.
CA certificate
Displays the Issued to, Issued by, and Validity period
information set in the stored CA certificate. It is blank if the
certificate is not set. You need to set CA certificate when
WPA/WPA2-EAP is selected in Security, when verifying the
authentication server certificate.
Select Clear to delete the stored certificate.
Network Setup
56
To Next Page
Loading...
Need help?
General
