Managing Projectors 149
When the problem has been fixed, EMP Monitor sends a message
indicating the problem has been resolved.
Using a Browser to Monitor the
Projector
If your projector is connected to a network, you can use a standard
web browser to monitor and control it.
1. Make sure that the projector is set up for your network, as
described on page 58. (Standby Mode in the Extended menu
should be set to
Network On to monitor the projector in standby
mode.) When using a browser to access the projector, you cannot
connect through a proxy server.
2. Open your web browser and enter the IP address of the projector
you want to monitor in the browser window.
If you’re not sure what the address of the projector is, turn the
projector on and select
Wired LAN or Wireless LAN from the
Network menu to display the IP address of the projector.
You see a login screen.
3. Do one of the following:
■ If you didn’t set a Web control password in the projector’s
Network menu, click
OK.
To Next Page
Loading...
Need help?
General