86 Presenting Through a Wireless Network
Connecting in Advanced Connection Mode
1. Click Manual search on the NS Connection screen.
2. Enter the IP address or the projector name for the projector you
want to connect to, and click
OK.
The Projector is added to the EMP NS Connection screen.
If the search fails to find a projector with the specified IP address,
the searching icon turns into a question mark. If this happens, run
EasyMP on your projector (see page 56) to check the projector’s
IP address, then repeat this step.
3. Click the projector you want to connect to and click the
Connect
button. If more than one projector is listed, you can select
additional projectors and connect to them at the same time.
To Next Page
Loading...
Need help?
General