Solving Problems 83
Power
light
Lamp
light
Temperature
light Description
Green Off Off The projector is operating normally.
Flashing
green
Off Off The projector is warming up. Wait for the image to appear.
Orange Off Off The projector is in standby or sleep mode. You can unplug
it or press the P Power button to turn it on.
Flashing
orange
Off Off The projector is shutting down. Wait for the light to stop
flashing and remain orange before unplugging it.
Red Off Flashing
orange
The projector is too hot. Make sure the temperature
surrounding the projector does not exceed 95
°F (35 °C)
and there is plenty of space around and under the projector
for ventilation. Clean the air filter and air vents, if
necessary. See page 74 for instructions.
Red Off Red The projector has overheated and turned itself off. Let it
cool for about five minutes, then turn it back on. Make sure
there is plenty of space around and under the projector for
ventilation. If you are using the projector at an altitude
above 4921 ft (1500 m), turn on High Altitude Mode as the
Operation setting in the Extended menu; see page 62. Also
clean the air filter and air vents; see page 74. If it continues
to overheat, you may need to replace the air filter.
Red Flashing
red
Off The lamp is burned out, broken, or not installed correctly;
or the lamp cover is open. Close the cover or replace or
reseat the lamp, if necessary, as described on page 76.
Also clean the air filter and air vents; see page 74. If you
are using the projector at an altitude above 4921 ft
(1500 m), turn on High Altitude Mode as the Operation
setting in the Extended menu; see page 62. If these
suggestions don’t work, contact Epson.
Orange Flashing
orange
Off Replace the lamp with a new one as soon as possible; see
page 76 for instructions. If you continue to use the lamp,
there is a risk it may break.
Red Off Flashing red There is a problem with the fan or a sensor. Turn the
projector off and unplug it. Contact Epson for help; see
page 91.
Flashing
red
Flashing
red
Flashing red There is an internal error in the projector. Turn the projector
off and unplug it. Contact Epson for help; see page 91.
To Next Page
Loading...
Need help?
General