62 Fine-tuning the Projector
Selecting Projector Setup Options
Use the Extended menu to customize the way you set up the
projector. You can configure the projector for rear and/or
ceiling/wall-mounted projection, change the language for the menus
and messages, set the screen background color, capture and store a
custom image or logo for the startup screen.
1. Press the
Menu button.
2. Select the
Extended menu.
3. Press
Enter. Then use the up and down arrow buttons and the
Enter button to set the following options:
■ Display
Messages:
Lets you turn screen messages on or off.
Display Background: Sets the screen background to Black,
Blue, or Logo when no image signal is available.
Startup Screen: Enables or disables display of the startup
screen when the projector is turned on.
A/V Mute: Sets the screen background to Black, Blue, or
Logo when the A/V Mute button is pressed.
Closed Caption: Turns on closed captioning using CC1 or
CC2.
note
Captions are not visible
when you display the
projector menus or use EMP
Monitor to access the
projector over a network.
To Next Page
Loading...
Need help?
General