Fine-tuning the Projector 63
■ User’s Logo
Turn on to display the image or logo you have captured
whenever the projector is turned on. See page 67 details.
■ Projection
Front:
Projector is in front of the screen.
Front/Ceiling: Projector is in front of the screen, mounted
upside-down from a wall, whiteboard mounting, or ceiling.
Rear: Projector is behind the screen.
Rear/Ceiling: Projector is behind the screen, mounted
upside-down from the ceiling.
To change from
Front to Front/Ceiling or Rear to
Rear/Ceiling, press and hold the A/V Mute button on the
remote control for five seconds.
■ Operation
Direct Power On:
When this feature is enabled, projection
starts as soon as you plug in the power cord. You don’t have
to press the P
Power button.
Sleep Mode: When enabled, the projector turns off the lamp
if it has not received any input signals for a period of time (as
defined in the Sleep Mode Timer setting).
Sleep Mode Timer: When Sleep Mode is on, you can set the
period of time before the projector turns off automatically,
from 1 to 30 minutes.
High Altitude Mode: When using the projector at an
altitude above 4,921 feet (1,500 m), turn this setting on to
ensure that the internal temperature of the projector is
regulated properly. Turn this setting off for lower elevations.
■ Standby Mode
Select Network On to allow the projector to be monitored
over a network when the projector is in standby mode (the
P
Power light is orange).
■ Language
Select the language to be used for the projector menus.
4. When you’re finished, press
Esc or Menu.
note
Logo settings cannot be
changed if the User’s Logo
Protect feature has been
turned on. See page 68.
note
When Direct Power On
is turned on, press the
P
Power button to turn
the projector off, wait until
the P
Power light turns a
steady orange, then unplug
the power cord.
To Next Page
Loading...
Need help?
General