4. Open the banner paper cover.
5. Move the right and left banner paper holders all the way out
to the sides and attach the banner paper roll to the roll
paper holder. Then slide the left banner paper holder to
match the paper roll’s width.
Note:
❑
For best results, use banner paper distributed by EPSON.
❑
Make sure that the left and right holders are snug against the
banner paper roll, but do not squeeze the paper too tightly;
otherwise the roll will not rotate properly.
❑
Be sure to load the banner paper roll in the holder so that the
paper feeds into the printer from the top of the roll.
A101-3
A-507-2
L
Loire-p Ref. Guide
Rev.c
A5 size Chapter 5
02-24-97 DR, pass 0
5-32
Paper Handling
To Next Page
Loading...
