Epson Stylus Photo RX585 - Page 64

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Removal of Exterior Parts 64
 Disassembly of Panel Assy
1. Remove the Panel Assy (p.63)
2. Remove the screws (x6) securing the Shield Plate, Panel Board and Ground Plate,
and remove the Shield Plate upward. (Fig. 4-7)
3. Release the hooks (x6), and remove the Panel Board. (Fig. 4-8)
4. Remove the screws (x2), and remove the LCD Module. (Fig. 4-9)
Figure 4-7. Removing the Screws (Shield Plate)
Figure 4-8. Removing the Panel Board
Figure 4-9. Removing the LCD Module
C A U T I O N
Take great care that the LCD surface is kept free from scratches
or dust and dirt.
In installation, make sure that there is no dust or dirt between the
LCD Module and Panel Assy.
 Tighten the screws for the LCD Module in the order specified.
(Fig. 4-9)
 When installing the Panel Board, match the positioning holes
with the guide pins (x4). (Fig. 4-8)
 Install the Shield Plate under the board-to-board cable.
 When installing the Shield Plate, match the positioning holes
with the guide pins (x2). (Fig. 4-7)
 When installing the Shield Plate, tighten the screws in the order
specified. (Fig. 4-7)
 After installing the Shield Plate, press each of the buttons and
check that a click is felt.
C.B.P-TITE 3x8 (x5)
Torque : 0.6±0.1N
·m
C.B.P-TITE 3x10
Torque : 0.6±0.01N
·m
2 1
3
4
56
Positioning holes and
guide pins
Ground Plate
Shield Plate
Hook (x6)
Positioning holes and
guide pins (x4)
C.B.P-TITE 2x8 (x2)
Torque : 0.4±0.1N
·m
LCD Module
2
1