Epson Stylus Photo RX585 - Page 74

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Removal of Exterior Parts 74
12. Remove the screws (x3) securing the Printhead. (Fig. 4-33)
13. Lift the Printhead, and disconnect the FFCs (x2). (Fig. 4-34)
Figure 4-34. Removing the Printhead
Figure 4-35. Releasing the Head FFCs
 See Page 90 for how to remove the cartridge cover.
 Connect the FFC with attention paid to the terminal surface.

When installing the Printhead, tighten the screws in the specified
order.
(Fig. 4-34)
 Install the Head FFC Cover and Head Cable Cover as shown
below.
A D J U S T M E N T
R E Q U I R E D
For replacing the Printhead, note down the head ID before
installing the Printhead. After reassembly, refer to the following
section and perform the necessary adjustments:
 5.2 Adjustment by Using Adjustment Program (p.101)
Head FFC Cover
The bottom protrusions (x2) and the
top sliding parts (x2) must be in
alignment.
Head Cable Cover
Engage the protrusion in the rear with
the carriage first and then fit the cover
onto the top protrusions (x2).
Head ID
C.B.P-TITE 2.6x8
Torque : 0.4±0.1N
·m
3
Printhead
2 1
Do not touch nozzle surface
Head FFC