The Control Panel 184
6. Press the Menu button to display PLATEN GAP, and then
press the Paper Feed or Paper Feed button to select
NARROW, STANDARD, WIDE, or WIDER.
7. Press the Menu button to save the selected platen gap
setting, and THICKNESS PAT appears on the LCD panel.
8. Press the Menu
button again to print the paper thickness
test printing pattern.
Paper thickness test pattern example:
9. Examine the printed pattern to determine which set of lines
are aligned (showing the smallest gap), and note the
corresponding number.
10. After the pattern is printed, THICKNESS NUM appears. Press the
Paper Feed or Paper Feed button to select the number
noted in step 9.
11. Press the Menu
button to save the selected value.
12. CUT METHOD appears. Press the Paper Feed or Paper Feed
button to select STANDARD, THICK, SLOW, THICK, FAST, or
THIN PAPER, and then press the Menu button.
13. PPR FEED ADJ appears. Press the Paper Feed or Paper
Feed button to set the paper feed amount, and then press
the Menu
button.
14. EJECT ROLLER appears. Select AUTO, SHEET, ROLL CURLED, or
ROLL NORMAL, and then press the Menu
button.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
smallest gap
To Next Page
Loading...
