Epson Stylus Pro 7400 - Page 229

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 229
5. Slide the ROLL TOP COVER leftward and remove the UNDULATE WASHER
and the DAMPER DISK. See Figure 4-31.
6. Press the ROLL TOP COVER to the left side to release its right end from the right
break pin, and remove the ROLL TOP COVER releasing its left end from the left
break pin. See Figure 4-32.
Figure 4-31. Removing the UNDULATE WASHER and DAMPER DISK
Figure 4-32. Removing the ROLL TOP COVER
C A U T I O N
 Be sure to reattach the UNDULATE WASHER and the
DAMPER DISK in the correct order.
Figure 4-30. Reinstalling the UNDULATE WASHER and
DAMPER DISK
 When performing the next step, be careful not to damage the
ROLL TOP COVER.
C H E C K
P O I N T
The next step is not required for the Stylus Pro 7400/7800 as they do
not have the break pins.
UNDULATE WASHER
DAMPER DISK
UNDULATE WASHER
DAMPER DISK
ROLL TOP COVER
5-1
5-2
Left Break Pin
Right Break Pin
6-1
6-2
6-3