Epson Stylus Pro 7400 - Page 228

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 228
4.2.3.8 ROLL TOP COVER
1. Remove the Spindle. See Section 4.2.2.4 on page 219.
2. Remove the two screws that secure the ROLL TRAY L ASSY. and remove it. See
Figure 4-28.
 Two C.C.S. M4 x 8 screws
3. Remove the E-RING, 4 that secures the TOP COVER SPACER and remove it.
See Figure 4-29.
4. Remove the three screws that secure the ROLL TRAY R ASSY. and remove it.
See Figure 4-29.
 Two C.C.S. M4 x 8 screws
 One roll bearing R screw 14
Figure 4-28. Removing the ROLL TRAY L ASSY.
Figure 4-29. Removing the ROLL TRAY R ASSY.
C H E C K
P O I N T
 The Stylus Pro 7400/7800 do not have the TOP COVER
SPACER and the E-RING,4.
 While performing the next step for the Stylus Pro 7400/7800,
hold the ROLL TOP COVER with your hand as it may slip off
the printer.
C.C.S. 4x8
ROLL TRAY L
ASSY.
Left Side of the Printer
Left Side of the Printer
C.C.S. 4x8
Roll bearing R screw 14
ROLL TRAY L ASSY.
TOP COVER SPACER
E-RING, 4
Right Side of the Printer