Epson Stylus Pro 7400 - Page 265

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 265
4.2.6.8 P Edge Sensor
1. Disconnect the connector of the P Edge Sensor from the BOARD ASSY., SUB.
See Section 4.2.4.4 on page 236.
2. Pull out the harness of the P Edge Sensor through the notch of the CR BOARD
HOLDER, and release the harness from the retaining clip.See Figure 4-100.
3. Remove the CUTTER HOLDER ASSY. See Section 4.2.5.6 on page 248.
4. Remove the screw that secures the Edge Sensor Holder and remove it. See Figure
4-101.
 One C.C.P. M3 x 8 screw
Figure 4-100. Releasing the P Edge Sensor Harness
Figure 4-101. Removing the Edge Sensor Holder
Set the two guide pins of the Edge Sensor Holder in the positioning
holes. See Figure 4-101.
CR BOARD HOLDER
Notch
P Edge Sensor
harness
Retaining Clip
Edge Sensor Holder
C.C.P. 3x8
Guide Pins