Epson Stylus Pro 7400 - Page 266

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 266
5. Cut the cable tie and release the P Edge Sensor harness.
6. Remove the screw that secures the P Edge Sensor and remove it.
 One C.B.P. M3 x 6 screw
Figure 4-102. Removing the P Edge Sensor
Set the positioning hole of the P Edge Sensor onto the guide pin. See
Figure 4-102.
P Edge Sensor
Cable Tie
C.B.P. 3x6
Guide Pins