EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 354
ADJUSTMENT PROCEDURE (SEPARATE WORKFLOW)
Printing Calibration Chart (at repair work site)
1. Turn the printer power on.
2. Start the adjustment program and select [Colorimetric Calibration Tool].
3. Click [Run] to start “Colorimetric Calibration Tool”.
4. Click [Print a Calibration Chart].
5. Perform Step 5 through 12 of “Adjustment Procedure (Entire Process Workflow)” to
print the Calibration chart.
6. Lay one plain paper on the print surface of the Calibration chart, put them in a clear file
together with the alignment check pattern, and send them to a place where the color
measuring is carried out.
Figure 5-83. Printing Calibration Chart
C A U T I O N
The printed calibration charts should be sent to a color-measuring
site immediately, as the color of the patch may be discolored in a
week.
To Next Page
Loading...
