Epson Stylus Pro 7400 - Page 355

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 355

Creating Color ID Data (at color measuring site)
1. Start the adjustment program, and select [Colorimetric Calibration Tool].
2. Click [Run] to start “Colorimetric Calibration Tool”.
3. Click [Create Color ID].
4. Select the type of the currently used black ink from the “BlackInk” pull-down menu,
and click [Next].
5. Perform Step 5 through 12 of “Adjustment Procedure (Entire Process Workflow)” to
print the calibration chart.
6. Enter the 10-digit serial numbers that are printed on the calibration chart, and click
[Next]
7. Click [Save], make sure that the file name is equivalent to the main unit serial number,
and save the color ID data (dat format).
8. Click [End].
9. Send the color ID data acquired in the procedure to the repair work site.
Figure 5-84. Generating Colorimetric Calibration ID Data
Perform the color
measurement