Epson Stylus Pro 7600 - Pump ASSY

EPSON Stylus Pro 7600/9600 Revision A
Disassembly & Assembly Disassembly and Assembly of Cleaning Mechanism 201
4.6.4 Pump ASSY
1. Remove the Maintenance ASSY. (See p.199)
2. Remove the one central screw (M3 × 4) of the Pump ASSY and remove the three parts
including the gear.
(See Figure 4-76)
3. Remove the two screws (M3 × 6) on the gear side.
4. Disconnect the tube from the Cap ASSY, remove the one screw (M 3
× 6) and remove
the Pump ASSY.
(See Figure 4-77)
Figure 4-76. Removing the Pump ASSY 1/2
Figure 4-77. Removing the Pump ASSY 2/2
A D J U S T M E N T
R E Q U I R E D
Once you have replaced the Pump ASSY, execute “CLEAR
COUNTERS” (See p.71).
Gear (3 parts)
Screw (M3×4)
Screws (M3×6) ×2
Pump ASSY
Screw (M3×6)
Ink tube