Epson Stylus Pro 9500 - 2.3 Paper Specifications

EPSON Stylus Pro 9500 Revision A
Product Description SPECIFICATIONS 10
PAPER SPECIFICATIONS
Size, roll paper {Minimum paper requirements}
Paper meeting the requirements described below
can be used with this printer, but neither the feeding
nor printout quality is guaranteed.
•Paper Size = Width 297~1118mm
(8.27~44.02”)
Length 720mm~45m
(28.35~1771.65”)
•Roll Size = 2” or 3” core
paper thickness = 103mm or less (4.05”)
(two 2” rolls)
150mm or less (5.9”)
(one 3” roll)
•Paper Thickness = 0.08~0.5mm (0.003~0.019”)
*1): There should be no wrinkles, fuzz, tearing or
folding, of the paper, etc.
* 2): The exclusive option (3” roll paper spindle)
should be used when using 3” core roll paper.
{Normal paper}
For paper meeting the following requirements, the
feeding operation only is guaranteed.
•Paper Size = Width 297~1118mm
(8.27~44.02”)
Length 720mm~45m
(28.35~1771.65”)
•Roll Size = 2” or 3” spindle
paper thickness = 103mm or less (4.05”)
(two 2” rolls)
150mm or less (5.9”)
(one 3” roll)
•Paper Thickness = 0.08~0.11mm (0.003~0.0043”)
•Paper Weight = 64~90gf/m
2
(17~24 lb.s)
•Paper Quality = Normal paper, recycled paper
*1: Use at normal room temperature
(15~25°C (59~77°F)
40~60% humidity)
*2: The printer exerts between 300~500gf to peel
off the rear edge of roll paper from the core
*3: The exclusive option (3” roll paper spindle) is
necessary when using 3” core roll paper.
*4: This product should be used in a place with a
normal room temperature environment
(Temperature: 15~25°C, Relative humidity:
40~60%)
*5: The guaranteed printable area for roll paper is
from the core to the point where it is cut off.
(Reference: The remaining paper length when the
paper comes off the roll is approximately 400 mm for
the upper holder and approximately 300 mm for the
lower holder.
{Special paper}
For special paper meeting the following
requirements, the feeding operation and print quality
are optimized.