Epson Stylus Pro 9500 - 5.2.9 Mechanism Adjustment

EPSON Stylus Pro 9500 Revision A
Adjustment Adjustment Steps 203
5.2.9 Mechanism Adjustment
This section describes the mechanism adjustments you need to perform when
replacing or removing certain parts. The parts and their corresponding
adjustments are as follows.
Table 5-19. Necessary Mechanism Adjustments
Parts Adjustment Necessary Tools Refer to
o Printhead
o Ink Damper
Assembly
o Cutter
solenoid
o Carriage
cover
o Cutter installation
position
adjustment.
o Carriage cover
height
o Cutter installation position
adjustment tool #F759
Code: 1059443
o CR Cover Position
Adjustment Tool #F724
code: 1049975
page 205
page 208
CR Motor CR Steel Belt
Tension
o Tension Gauge #F712
code: 1047744
Standard: 200g
page 213
PF Motor PF Belt Tension
o Tension Gauge
code: B747700300
Standard: 4000g
page 213
PG Motor Gear Backlash confirm by sight page 214
Lower Paper
Guide
o Paper guide L
installation
position
adjustment
o Cutter Position
o Paper guide L installation
position adjustment tool
#F755
Code: 1059434
confirm by sight or by
measuring with a ruler
page 204
I/H Assembly I/H Handle Gear
position match
confirm by sight page 214
P THICK sensor Self-diagnostic mode
test - "Paper
Thickness"
- page 215
CR Encoder
Sensor
CR encoder sensor
installation position
adjustment
o CR ENC Installation
adjustment tool #F766
Code: 1060655
page 210
PF Encoder
Sensor
o PF encoder
sensor installation
position
adjustment
o PF encoder
sensor installation
position
adjustment 2
o PF ENC installation
adjustment tool #764
Code: 1060658
o PF ENC installation
adjustment tool 2 #765
Code: 1060657
page 211
page 211
Cover Open R/L
sensor
o Front cover
positioning
adjustment
o Self diagnostic
mode test -
"Cover"
o Front cover positioning
tool #F754
Code: 1059420
page 215
Table 5-19. Necessary Mechanism Adjustments
Parts Adjustment Necessary Tools Refer to