Epson Stylus Pro 9500 - 2.4 Adjustment Menu

EPSON Stylus Pro 9500 Revision A
Adjustment Adjustment Steps 168
5.2.4 Adjustment Menu
The Adjust menu allows you to make certain adjustments to the printer
mechanism and controls, for example head angle adjustment, print position
adjustment, paper feeding correction, and firmware-control setting.
Table 5-5. Adjustment Menu Items
Adjustment Item Description
Capping Position Sets the Capping position (automatic Adjustment)
Paper Skew Check Verifies the degree of skew (slant) allowed during printing
Head Rank Input Sets the printhead ID
Head Nozzle Check Prints the check pattern to make sure the nozzles are not
clogged
B Head Angle Adjusts the angle of the B Head (mechanism adj.)
C Head Angle Adjusts the angle of the C Head (mechanism adj.)
BC Head Height Verifies the B/C Head nozzles are at the same height
(mechanism adj.)
Bi-D Print Position Verifies the printed lines match up when performing bi-
directional printing.
Head Gap Adjusts the B/C Head Gap as well as sets the left margin
R Flush Point Adjusts the flush position on the HP side
L Flush Point Adjusts the flush position on the opposite side
Feed Correction Checks paper feeding (w/ruler)
Top & Bottom Checks the top and bottom margins (w/ruler)
Rear Paper Sensor
Position
Sets the detection position of the rear paper-edge sensor
Test Pattern Print Checks print quality (prints setting information, check
pattern and so on)
Head Cleaning Initiates cleaning/flushing of the heads and ink path
Counter Clear Resets all counters
CAUTION
n When conducting on-site service/repairs, do not
select "Head Cleaning" as this requires a separate
head cleaning cartridge to work properly.
n Only select "Counter Clear" when replacing the
Waste Ink Pads and related parts.