Epson Stylus Pro 9500 - 2.5 Test Menu

EPSON Stylus Pro 9500 Revision A
Adjustment Adjustment Steps 189
5.2.5 Test Menu
The Test menu tests or checks the operation of the control circuit board.
NOTE: The D/A correction in the above table should not be
implemented.
The menu items and their order in the menu are shown below.
CHECK
PO INT
This menu is also to used for operation checks of
each of the sensors, etc. in Chapter 3,
“Troubleshooting.”
Table 5-10. Test Menu Items
Test Item Description
Version
o Program
o Backup parameters
o DIP-SW
o Board Rev.
Control Panel
o Panel buttons
o LCD panel display
o LED indicators
Sensors HP, Cover Open, Release Lever, P_FRONT, P_Rear,
Paper Thickness, PG, Thermistor, I/C Holder Levers,
Ink ID, I/C, and Ink Low
Encoder CR Motor, PF Motor
Fan On/Off confirmation
Elec.
o Maintenance Record
o Fatal Error Record
D/A Revision Factory use for Head voltage correction - do not attempt
Head Signal Factory use for Head pulse check - do not attempt
[Pause] returns you
to previous menu
[SelecType]
[Enter]
Other
menus
[Pause]
Test: Version
Test: Panel
Test: Sensor
Test: Encoder
Test: Fan
Test: Elec.
Test: D/A Revision
Test: Head Signal
[Item]